DMX CARD MODULES
Showcraft manufactures a range of modules that can be integrated into new or existing DMX setups. The modules are available without power supplies or casings, thereby reducing the cost. They are mostly designed to add to existing equipment enabling it to receive DMX-512 control signals. You will need to know some basic electronic practices to set them up. Alternatively, we can mount them into cases/wall plates with power supplies to suit your requirements.
 |
24 channel DMX to Analogue(0 to +/-10v) Converter This unit is positive or negative output for converting any analogue dimmer rack to run off DMX control. It features full 512 channel start address, power led, dmx signal led , plus or minus voltage output, output adjust from 8 to 14 volts "full". Connections are made with 2 x DB15 connectors or 2 x 16 pin IDC and the PCB requires 15-0-15vac 300Ma power supply. |
 |
Single Channel DMX Opto outlet This module is an optical isolation unit that galvanically separates the supply DMX from a DMX branch. The module can be used by itself, or in multiples. The DMX input uses 1 load , and the output can provide signal for 32 loads. These are ideal for building custom DMX distribution racks , and for use in large DMX installations to ensure signal integrity. Signal/power input via screw terminal blocks or 10 pin IDC .Requires 8 to 12 volts, at 200 ma peak per module. See the datasheet/ application notes for more information on wiring up. |